3.65. From router Web Page, changed router IP to 192.168.2.1. It accepts the changes but HANGS at the next page where it's saving. I tried router IP of 192.168.1.2 but it gives error "router IP equals subnet".
I have the latest firmware upgrade from Linksys installed and DHCP enabled.
Using the Setup Software, I can get the router to go through the steps of installation until the "connect power cord" page. It hangs and says I'm not connected to the internet.
Does anyone have any idea what router IP settings I should use to set up this router?
Question about
Running Vista 64-bit. Trying to install on STATIC IP address of 192.168.1.20, subnet 255.255.255.0, default gateway 192.168.1.20 (from Rural ISP). DNS 205.171.
follow this question
share:
Related questions
1 user following this question:
This question has been viewed 18 times.
Last activity .
Tips for giving the best answers
Sometimes it's just little details that separates a great and not so great answer! Here are a few simple tips to keep in mind:
- 1
- Be complete and thorough. Don't skimp on the details!
- 2
- Try not to answer with a question. Because that's not really an answer, right?
- 3
- A little research goes a long way. Back up your claims and assumptions!
- 4
- Try to be patient, tech questions can be complicated.
- 5
- You are awesome for both reading this and answering questions.