Discussion about
Anyone having a problem sideloading? I plug in my usb cable into 2 different computers and 4 different usb ports and it charges O.K.
but the computers do not see the nook for sideloading. ADE also does not see it. Have used a non B&N cable for 11 months with no problem and both the non and the white B&N cable malfunction. Did a factory reset and was O.K. for a few days then does not operate properly again.
My dedicated cable is approx 10 months old and the computer end stays plugged in. The nook end is the one that gets plugged in and out. That cable charges fine and the computer does not always recognize, not usually recognize the nook 3g.
The B&N white cable basically has seen no use for the last 10 months and the 1st time I tried it after the dedicated cable was having problems it worked fine then that cable also started to act up.
I really think it is 1.5 software update related. as you say, the odds of 2 cables going at the same time?
Going to wait and see, I have over 11 months left on my warranty.
By the way, the My Documents section is acting up since the 1.5 update. After ejecting from the computer there is an empty My Documents that should have over 900 titles in it. Find new content does not find my books and I have to do a reboot to see my books in My Documents.
The B&N white cable basically has seen no use for the last 10 months and the 1st time I tried it after the dedicated cable was having problems it worked fine then that cable also started to act up.
I really think it is 1.5 software update related. as you say, the odds of 2 cables going at the same time?
Going to wait and see, I have over 11 months left on my warranty.
By the way, the My Documents section is acting up since the 1.5 update. After ejecting from the computer there is an empty My Documents that should have over 900 titles in it. Find new content does not find my books and I have to do a reboot to see my books in My Documents.
